JEM PPF Full Front Exterior Kit

JEM Large Adhesive Kit

Kit contents:

• 300 ml shampoo/water solution
• 300 ml IPA/water solution
• 10 cm squeegee
• 40x40 cm microfiber cloth
• Utility knife

PPF JEM Application:

• If possible, remove parts from the vehicle that might release dirt during application (badges, trims, logos, lights, handles, etc.)
• Thoroughly wash the vehicle. Remove all contaminants from the paint (asphalt, flying rust, adhesive residues from protective film used during transport of new vehicles, etc.)
• Once positioned for application, it is recommended to use wheel covers and connect the vehicle to a maintenance power source.
• Try to minimize dust in the vehicle’s surroundings during work and avoid applying while wearing clothes that may shed lint.
• Dry PPF after peeling the carrier layer is charged with static electricity, so it is important to work carefully to avoid dust particles sticking to the adhesive side.
• Use the correct solution and application technique to prevent damage to the adhesive, which could cause undesirable streaks, bubbles, adhesive tears, etc.
• Degrease the edges of the part to be glued with pure IPA and decontaminate each part before application with soft clay.
• Lightly spray the shampoo and distilled water solution on both the part to be glued and both sides of the PPF (distilled water does not leave spots on the vehicle after drying). For 500 ml of water, add 2 - 2.5 ml shampoo (more shampoo is suitable at higher workshop temperatures or for complex parts).
• The shampoo solution protects the adhesive during handling and positioning of the PPF on the part but will not activate the adhesive on the paint. Therefore, rinse it off with clean water, preferably again distilled water, poured from a pressure sprayer in larger amounts.
• For positioning and stretching the material, hold the foil corners on surrounding parts and rinse the shampoo solution preferably always outside the part where the PPF is applied (e.g., hood held on fenders and below on lights and bumper).
• Carefully squeegee off excess shampoo solution to avoid any residue or bubbles; rinse edges with clean water.
• If you need to fix the material immediately, use a distilled water and IPA solution in a 1:3 ratio.
• Dry the applied film with a towel and check that there is no dirt or water residue under the film anywhere.
• Cut off excess material as needed, depending on the part type, by 3-4 mm for folding behind the edge.
• Fold immediately using non-woven fabric and a heat gun. Gradually push out all water from the edges while heating the adhesive side with a heat gun set to 650°C.
• The vehicle can be handed over after 24-48 hours depending on the season.

JEM PPF s.r.o. is the exclusive importer of protective PPF films produced by the JEM company. We offer all documentation, technology, and quality guaranteed by many years of experience in the Asian market. Due to direct connection with the manufacturer, we can offer the production of all types of PPF films on order according to client requirements. We provide all documentation from insurance, loading, transport, customs clearance, unloading, and delivery to the destination as required by the client.